[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

dmesg, current MP on dual pIII

All fine (apm and usb disabled in bios due to _very_ old
linux being run daily on the box, what a shame :)

booting tftp:bsd.mp: 4873308+861524 [52+226400+204452]=0x5e165c
entry point at 0x100120
[ using 431276 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2004 OpenBSD. All rights reserved.  http://www.OpenBSD.org
OpenBSD 3.5-current (GENERIC.MP) #1: Fri Jun 25 15:05:59 EDT 2004
cpu0: Intel Pentium III ("GenuineIntel" 686-class) 802 MHz
real mem  = 536322048 (523752K)
avail mem = 488828928 (477372K)
using 4278 buffers containing 26918912 bytes (26288K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 01/15/99, BIOS32 rev. 0 @ 0xfdb60
apm0 at bios0: Power Management spec V1.2 (BIOS mgmt disabled)
apm0: APM power management enable: power management disabled (1)
apm0: APM engage (device 1): power management disabled (1)
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0x10000
pcibios0: PCI BIOS has 9 Interrupt Routing table entries
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371AB PIIX4 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xa000 0xcc000/0x1000
mainbus0: Intel MP Specification (Version 1.4) (INTEL    440BX       )
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: apic clock running at 100 MHz
cpu1 at mainbus0: apid 1 (application processor)
cpu1: Intel Pentium III ("GenuineIntel" 686-class) 802 MHz
mainbus0: bus 0 is type PCI
mainbus0: bus 1 is type PCI
mainbus0: bus 2 is type ISA
ioapic0 at mainbus0: apid 2 pa 0xfec00000, version 11, 24 pins
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX AGP" rev 0x03
ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "3DFX Interactive Voodoo3" rev 0x01
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <QUANTUM FIREBALLP LM30>
wd0: 16-sector PIO, LBA, 28629MB, 58633344 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <PLEXTOR, DVDR PX-708A, 1.04> SCSI0 5/cdrom removable
atapiscsi1 at pciide0 channel 1 drive 1
scsibus1 at atapiscsi1: 2 targets
cd1 at scsibus1 targ 0 lun 0: <DVD-16X, OEM316B, 1.00> SCSI0 5/cdrom removable
cd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
cd1(pciide0:1:1): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01pci_intr_map: no mapping for pin D
: couldn't map interrupt
"Intel 82371AB Power Mgmt" rev 0x02 at pci0 dev 7 function 3 not configured
wi0 at pci0 dev 15 function 0 "Intersil PRISM2.5 Mini-PCI WLAN" rev 0x01: apic 2 int 16 (irq 10)wi0: init failed
: unable to read station address
fxp0 at pci0 dev 16 function 0 "Intel 82557" rev 0x08: apic 2 int 17 (irq 11), address 00:02:b3:10:b6:6e
inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 4
eap0 at pci0 dev 18 function 0 "Ensoniq CT5880" rev 0x02: apic 2 int 18 (irq 5)
ac97: codec id 0x83847608 (SigmaTel STAC9708/11)
ac97: codec features 18 bit DAC, 18 bit ADC, SigmaTel 3D
audio0 at eap0
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
lm0 at isa0 port 0x290/8: W83781D
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 0 netmask 0 ttymask 0
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
wd0: no disk label
dkcsum: wd0 matched BIOS disk 80
root on wd0¿?
rootdev=0x69 rrootdev=0x369 rawdev=0x362