[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Problems with 3.7 on Wrap and detecting ram



Hi folks,


I own a Wrap box, very similar to the Soekris NET4801 except that it is lacking USB, IDE and PXE among other minor things.


I own this model:

http://shop.tronico.net/pd1100964260.htm?categoryId=0

I installed 3.7 from my offical CD on a 512MB CF card per card reader and herefore use GENERIC. So far so good.

The Problem is, that OpenBSD only detecs 64MB ran instead of 128 MB. From dmesg:
real mem = 66695168 (65132K)
avail mem = 53452800 (52200K)


From sysctl:
hw.physmem=66695168
hw.usermem=66486272

Do I have to compile something into the kernel in order to get access to all installed ram?

My detailed installation steps can be found here:
http://blog.innerewut.de/articles/2005/05/14/openbsd-3-7-on-wrap

Thanks,
Jonathan

dmesg:

OpenBSD 3.7 (GENERIC) #50: Sun Mar 20 00:01:57 MST 2005
deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
RTC BIOS diagnostic error 80<clock_battery>
cpu0: Geode(TM) Integrated Processor by National Semi ("Geode by NSC" 586-class) 267 MHz
cpu0: FPU,TSC,MSR,CX8,CMOV,MMX
cpu0: TSC disabled
real mem = 66695168 (65132K)
avail mem = 53452800 (52200K)
using 839 buffers containing 3436544 bytes (3356K) of memory
RTC BIOS diagnostic error 80<clock_battery>
mainbus0 (root)
bios0 at mainbus0: AT/286+(ac) BIOS, date 07/13/04, BIOS32 rev. 0 @ 0xfc554
pcibios0 at bios0: rev 2.1 @ 0xf0000/0x10000
pcibios0: pcibios_get_intr_routing - function not supported
pcibios0: PCI IRQ Routing information unavailable.
pcibios0: PCI bus #0 is the last bus
cpu0 at mainbus0
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Cyrix GXm PCI" rev 0x00
sis0 at pci0 dev 14 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 10, address 00:0d:b9:01:92:d0
nsphyter0 at sis0 phy 0: DP83815 10/100 PHY, rev. 1
sis1 at pci0 dev 15 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 9, address 00:0d:b9:01:92:d1
nsphyter1 at sis1 phy 0: DP83815 10/100 PHY, rev. 1
sis2 at pci0 dev 16 function 0 "NS DP83815 10/100" rev 0x00: DP83816A, irq 11, address 00:0d:b9:01:92:d2
nsphyter2 at sis2 phy 0: DP83815 10/100 PHY, rev. 1
gscpcib0 at pci0 dev 18 function 0 "NS SC1100 ISA" rev 0x00
gpio0 at gscpcib0: 64 pins
"NS SC1100 SMI/ACPI" rev 0x00 at pci0 dev 18 function 1 not configured
pciide0 at pci0 dev 18 function 2 "NS SCx200 IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <SAMSUNG CF/ATA>
wd0: 1-sector PIO, LBA, 497MB, 1018080 sectors
wd0(pciide0:0:0): using PIO mode 4
"NS SCx200 AUDIO" rev 0x00 at pci0 dev 18 function 3 not configured
geodesc0 at pci0 dev 18 function 5 "NS SC1100 X-Bus" rev 0x00: iid 6 revision 3 wdstatus 0
isa0 at gscpcib0
isadma0 at isa0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
gscsio0 at isa0 port 0x2e/2: SC1100 SIO rev 1: ACB1 ACB2
iic0 at gscsio0
iic1 at gscsio0
lmtemp0 at iic1 addr 0x48: LM77
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
biomask f1e7 netmask ffe7 ttymask ffe7
pctr: no performance counters in CPU
nvram: invalid checksum
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
clock: unknown CMOS layout
WARNING: clock time much less than file system time
WARNING: using file system time
WARNING: CHECK AND RESET THE DATE!



--

Jonathan Weiss
jw_(_at_)_innerewut_(_dot_)_de
http://blog.innerewut.de