[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Unsupported hw?
- To: misc_(_at_)_openbsd_(_dot_)_org
- Subject: Re: Unsupported hw?
- From: Maxim Bourmistrov <maxim_(_at_)_chl_(_dot_)_chalmers_(_dot_)_se>
- Date: Mon, 21 Feb 2005 17:34:26 +0100
it's actually something else.
I have only 2 disk inside.
On Monday 21 February 2005 05:48, Marco Peereboom wrote:
> Your drive didn't respond properly. If it keeps doing this you really
> need to remove it from your system.
> On Feb 20, 2005, at 5:40 AM, Maxim Bourmistrov wrote:
> > Hi!
> > I have this piece of hw in one of my boxes:
> > sd2 at scsibus0 targ 6 lun 0: <, , > SCSI0 0/direct fixed
> > sd2: could not mode sense (4/5); using fictitious geometry
> > sd2(mpt0:6:0): could not get size
> > sd2: drive offline
> > I guess it's some kide of controller chipset on this one:
> > mpt0 at pci2 dev 5 function 0 "Symbios Logic 53c1030" rev 0x08: irq 7
> > mpt0: sending FW Upload request to IOC (size: 36, img size: 40048)
> > mpt0: target 0 Synchronous at 160MHz width 16bit offset 63 QAS 0 DT 1
> > IU 1
> > mpt0: target 1 Synchronous at 160MHz width 16bit offset 63 QAS 0 DT 1
> > IU 1
> > mpt0: target 6 Asynchronous at 0MHz width 8bit offset 0 QAS 0 DT 0 IU
> > 0 -> sd2
> > Any ideas what should I do with it?
> > Should I disable it in BIOS or should I leave it as it is?
> > ----------------------------------------------
> > The second box gets this kind of error while trying init cardbus:
> > cbb0: bad Vcc request. sock_ctrl 0x700, sock_status 0x76f
> > cardslot0 at cbb0 slot 0 flags 0
> > cardbus0 at cardslot0: bus 2 device 0 cacheline 0x0, lattimer 0x40
> > pcmcia0 at cardslot0
> > cbb1: bad Vcc request. sock_ctrl 0x700, sock_status 0x720
> > cardslot1 at cbb1 slot 1 flags 0
> > cardbus1 at cardslot1: bus 3 device 0 cacheline 0x0, lattimer 0x40
> > pcmcia1 at cardslot1
> > ?V card, 0x63996399
> > cbb1: bad Vcc request. sock_ctrl 0x63996388, sock_status 0x63996399
> > Any way to fix it? Or should I wait till next release?
> > Thx!
> > //maxim