[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: OpenBSD 3.6 - Davicom DM9009 interface issue...
- To: misc_(_at_)_openbsd_(_dot_)_org
- Subject: Re: OpenBSD 3.6 - Davicom DM9009 interface issue...
- From: alberto_(_dot_)_puebla1_(_at_)_us_(_dot_)_army_(_dot_)_mil
- Date: Thu, 23 Dec 2004 08:31:37 -0500
----- Original Message -----
From: Ben Morrow <imension_(_at_)_gmail_(_dot_)_com>
Date: Thursday, December 23, 2004 4:14 am
Subject: Re: [misc] OpenBSD 3.6 - Davicom DM9009 interface issue...
> First, the Davicom DM9009 is listed as being supported by OpenBSD.
> # Davicom DM9009, DM9100, DM9102, and DM9102A based PCI adapters (dc),
> * Jaton XpressNet
> That being said, I would check your bios settings and make sure
> PnP OS
> is set to NO. Then I would see about manually changing the IRQ
> settings for your pci slots. The problem simply sounds like an irq
> On Wed, 22 Dec 2004 22:56:44 -0500, alberto_(_dot_)_puebla1_(_at_)_us_(_dot_)_army_(_dot_)_mil
> <alberto_(_dot_)_puebla1_(_at_)_us_(_dot_)_army_(_dot_)_mil> wrote:
> > advice on the NIC...
> > Hey, was hoping if someone could help out, I think I've tried
> enough searching and the such....Wouldv'e posted dmesg output if I
> could've gotten online.....
> > Anyway I wrote it down... :
> > --
> > dc0 at pci0 dev 13 function 0 "Davicom DM9009" rev
> 0x31pci_intr_map: no mapping for pin A: couldn't map interrupt
> > --
> > I've tried googling... I don't think this is an issue with
> drivers right?...there is no /etc/hostname.dc0....
> > Any input on this matter would be greatly appreciated...
Hey, Thanks for the timely response Ben,sounds reasonable...
The only problem is that for some reason certain parts of the BIOS is locked on this old Compaq Presario 2266...
Specifically the PnP OS settings..I think that the culprit is that a user password is set, but not for password on boot..??
I've tried reformatting the measly 4G HDD about 4 times now to no avail...The BIOS settings just won't reset...What to do?
On a positive note, The IRQ settings for the pci slots are configurable...=[[
Thanks in advance...
Visit your host, monkey.org