[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Help interpreting hard disk failure



The question I have is should I buy a new mother board or hard disk. I have an i386 (ASUS A7V333) which failed to boot due to a post reported hard disk failure. This box i had configured for dual boot openbsd and freebsd. The hard disk was configured using the freebsd fdisk. To test the hard disk I tried adding it to a G3 mac I have running OpenBSD 3.3. The fdisk, disklabel, (for the questionable disk) and dmesg from the G3 is included below. It shows the OpenBSD slice but not the freebsd. The disklabel makes no sense to me.

Is this disklabel and fdisk output a problem of moving a HD from one architecture/OS to another?

Is there enough information here to decide if the hard disk is bad or not?

bricker:kerndtr {107} sudo fdisk wd0
Disk: wd0       geometry: 12556/16/63 [12656448 Sectors]
Offset: 0       Signature: 0xAA55
         Starting       Ending       LBA Info:
 #: id    C   H  S -    C   H  S [       start:      size   ]
------------------------------------------------------------------------
*0: 06    0   0  2 -    2   0 33 [           1:        2048 ] DOS > 32MB
 1: 00    0   0  0 -    0   0  0 [           0:           0 ] unused
 2: 00    0   0  0 -    0   0  0 [           0:           0 ] unused
 3: A6    3   0  1 - 12555  15 63 [        3024:    12653424 ] OpenBSD

bricker:kerndtr {108} sudo disklabel wd1
# using MBR partition 0: type A6 off 63 (0x3f) size 62910477 (0x3bff00d)
# /dev/rwd1c:
type: ESDI
disk: ESDI/IDE disk
label: Maxtor 6Y080L0
flags:
bytes/sector: 512
sectors/track: 63
tracks/cylinder: 16
sectors/cylinder: 1008
cylinders: 16383
total sectors: 160086528
rpm: 3600
interleave: 1
trackskew: 0
cylinderskew: 0
headswitch: 0           # microseconds
track-to-track seek: 0  # microseconds
drivedata: 0

16 partitions:
# size offset fstype [fsize bsize cpg]
a: 62910477 63 unused 0 0 # (Cyl. 0*- 62411*)
c: 160086528 0 unused 0 0 # (Cyl. 0 - 158815)
i: 97161120 62910540 unknown # (Cyl. 62411*- 158801*)



bricker:kerndtr {110} cat /var/run/dmesg.boot
[ using 311836 bytes of bsd ELF symbol table ]
console out [ATY,Rage128y]console in [keyboard] ADB found
: memaddr 88000000 size 8000000, : consaddr 88000000, : ioaddr 80a20000, size 20000: memtag 8000, iotag 8000: width 640 linebytes 640 height 480 depth 8
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2003 OpenBSD. All rights reserved. http://www.OpenBSD.org


OpenBSD 3.3-stable (GENERIC) #0: Sat Sep 6 18:39:31 PDT 2003
root_(_at_)_bricker_(_dot_)_a_(_dot_)_kerndt_(_dot_)_com:/usr/src/sys/arch/macppc/compile/GENERIC
real mem = 335544320 (327680K)
avail mem = 233885696 (228404K)
using 1254 buffers containing 82182144 bytes of memory
mainbus0 (root)
cpu0 at mainbus0: 750 (Revision 202): 350 MHz: 1MB backside cache
mpcpcibr0 at mainbus0: grackle, Revision 0x40
pci0 at mpcpcibr0 bus 0
pchb0 at pci0 dev 0 function 0 "Motorola MPC106 Host-PCI" rev 0x40
ppb0 at pci0 dev 13 function 0 "DEC 21154 PCI-PCI" rev 0x02
pci1 at ppb0 bus 1
vendor "Texas Instruments", unknown product 0x8000 (class serial bus, subclass Firewire, rev 0x02) at pci1 dev 0 function 0 not configured
pciide0 at pci1 dev 1 function 0 "CMD Technology PCI0646" rev 0x07: DMA, channel 0 configured to native-PCI, channel 1 configured to native-PCI
pciide0: using irq 26 for native-PCI interrupt
wd0 at pciide0 channel 0 drive 0: <Maxtor 90648D3>
wd0: 16-sector PIO, LBA, 6179MB, 12556 cyl, 16 head, 63 sec, 12656448 sectors
wd1 at pciide0 channel 0 drive 1: <Maxtor 6Y080L0>
wd1: 16-sector PIO, LBA, 78167MB, 16383 cyl, 16 head, 63 sec, 160086528 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
wd1(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2
pciide0: channel 1 ignored (disabled)
em0 at pci1 dev 3 function 0 "Intel PRO/1000MT (PWLA8390MT)" rev 0x02: irq 24, address: 00:07:e9:19:e9:48
ahc0 at pci1 dev 4 function 0 "Adaptec AHA-2940U" rev 0x00: irq 25
ahc0: aic7880: Ultra Single Channel A, SCSI Id=7, 16/255 SCBs
scsibus0 at ahc0: 8 targets
ahc0: target 2 synchronous at 10.0MHz, offset = 0xf
sd0 at scsibus0 targ 2 lun 0: <SEAGATE, ST39140N, 1498> SCSI2 0/direct fixed
ahc0: target 2 using tagged queuing
sd0: 8683MB, 9006 cyl, 8 head, 246 sec, 512 bytes/sec, 17783240 sec total
ahc0: target 5 synchronous at 10.0MHz, offset = 0xf
st0 at scsibus0 targ 5 lun 0: <SONY, SDT-9000, 0601> SCSI2 1/sequential removable
st0: density code 0x25, 512-byte blocks, write-enabled
macobio0 at pci1 dev 5 function 0 "Apple Paddington" rev 0x00
macintr0 at macobio0
pciide0 irq 26 level 0 fun 30c388 arg e0430000
em0 irq 24 level 1 fun 320d0c arg e0437800
ahc0 irq 25 level 0 fun 112a70 arg e042c600
zsc0 at macobio0: irq 15,16
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1
awacs: matched davbus nreg 24 nintr 12
awacs0 at macobio0: irq 17,8,9 headphones
audio0 at awacs0
adb0 at macobio0 irq 18: via-cuda 1 targets
aed0 at adb0 addr 0: ADB Event device
akbd0 at adb0 addr 2: extended keyboard
wskbd0 at akbd0 (mux 1 ignored for console): console keyboard
wdc0 at macobio0 irq 13: DMA transfer
atapiscsi0 at wdc0 channel 0 drive 0
scsibus1 at atapiscsi0: 2 targets
cd0 at scsibus1 targ 0 lun 0: <MATSHITA, CD-ROM CR-589, GA0W> SCSI0 5/cdrom removable
atapiscsi1 at wdc0 channel 0 drive 1
scsibus2 at atapiscsi1: 2 targets
sd1 at scsibus2 targ 0 lun 0: <IOMEGA, ZIP 100, 14.A> SCSI0 0/direct removable
sd1: drive offline
cd0(wdc0:0:0): using BIOS timings, DMA mode 2
sd1(wdc0:0:1): using BIOS timings
bm0 at macobio0 irq 42,33: address 00:50:e4:d0:98:18
lxtphy0 at bm0 phy 0: LXT970 10/100 media interface, rev. 1
ohci0 at pci1 dev 6 function 0 "Opti RM861HA" rev 0x10: irq 28, OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
vgafb0 at pci0 dev 16 function 0 "ATI Rage 128 GL" rev 0x00, mmio
wsdisplay0 at vgafb0: console (std, vt100 emulation), using wskbd0
bootpath: '/pci/@d/pci-ata_(_at_)_1/ata-4_(_at_)_0/disk_(_at_)_0/bsd'
boot device: wd0.
root on wd0a
rootdev=0x0 rrootdev=0xb00 rawdev=0xb02




Visit your host, monkey.org