[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

cbb0: bad vcc request



Hi all,

I have a network engine running OpenBSD 3.3. I got today a pci adapter so that I can install a wireless card. At boot up, I get the following error message:

cbb0 at pci2 dev 14 function 0 "Ricoh 5C475 PCI-CardBus" rev 0x80: irq 5
ahc1 at pci2 dev 15 function 0 "Adaptec AHA-2940U2 U2" rev 0x00: irq 11
ahc1: aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/255 SCBs
scsibus1 at ahc1: 16 targets
ahc1: target 0 synchronous at 40.0MHz, offset = 0x3f
ahc1: target 0 using tagged queuing
sd0 at scsibus1 targ 0 lun 0: <IBM, DPSS-336950N, S96H> SCSI3 0/direct fixed
sd0: 35239MB, 14627 cyl, 10 head, 493 sec, 512 bytes/sec, 72170880 sec total
cbb0: bad Vcc request. sock_ctrl 0xffffff88, sock_status 0xffffffff



Thank you

Here's the complete dmesg.

OpenBSD 3.3 (GENERIC) #44: Sat Mar 29 13:22:05 MST 2003
deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium III (Coppermine) ("GenuineIntel" 686-class) 596 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36, SER,MMX,FXSR,SIMD
real mem = 1073328128 (1048172K)
avail mem = 990437376 (967224K)
using 4278 buffers containing 53768192 bytes (52508K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 07/15/95, BIOS32 rev. 0 @ 0xfdb50
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0x10000
pcibios0: PCI BIOS has 8 Interrupt Routing table entries
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371AB PIIX4 ISA" rev 0x00)
pcibios0: PCI bus #3 is the last bus
bios0: ROM list: 0xc0000/0x9600 0xc9800/0x5800 0xcf000/0xa000
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82440BX PCI-AGP" rev 0x00
ppb0 at pci0 dev 1 function 0 "Intel 82440BX AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "Chips and Technologies 69000" rev 0x64
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
pciide0: channel 0 disabled (no drives)
atapiscsi0 at pciide0 channel 1 drive 1
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <TEAC, CD-224E, 1.5A> SCSI0 5/cdrom removable
cd0(pciide0:1:1): using PIO mode 4, DMA mode 2
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01pci_intr_map: no mapping for pin D
: couldn't map interrupt
"Intel 82371AB Power Mgmt" rev 0x02 at pci0 dev 7 function 3 not configured
fxp0 at pci0 dev 17 function 0 "Intel 82557" rev 0x08: irq 10, address 00:d0:a8:00:63:9c
inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 4
fxp1 at pci0 dev 18 function 0 "Intel 82557" rev 0x08: irq 5, address 00:d0:a8:00:63:9d
inphy1 at fxp1 phy 1: i82555 10/100 media interface, rev. 4
ppb1 at pci0 dev 20 function 0 "DEC 21152 PCI-PCI" rev 0x03
pci2 at ppb1 bus 2
cbb0 at pci2 dev 14 function 0 "Ricoh 5C475 PCI-CardBus" rev 0x80: irq 5
ahc1 at pci2 dev 15 function 0 "Adaptec AHA-2940U2 U2" rev 0x00: irq 11
ahc1: aic7890/91: Ultra2 Wide Channel A, SCSI Id=7, 32/255 SCBs
scsibus1 at ahc1: 16 targets
ahc1: target 0 synchronous at 40.0MHz, offset = 0x3f
ahc1: target 0 using tagged queuing
sd0 at scsibus1 targ 0 lun 0: <IBM, DPSS-336950N, S96H> SCSI3 0/direct fixed
sd0: 35239MB, 14627 cyl, 10 head, 493 sec, 512 bytes/sec, 72170880 sec total
cbb0: bad Vcc request. sock_ctrl 0xffffff88, sock_status 0xffffffff
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 3 device 0 cacheline 0x0, lattimer 0x20
pcmcia0 at cardslot0
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
biomask 8860 netmask 8c60 ttymask 9ce2
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
dkcsum: sd0 matched BIOS disk 80
root on sd0a
rootdev=0x400 rrootdev=0xd00 rawdev=0xd02
$




Visit your host, monkey.org