wireless card oddity

[Rod Dorman <rodd_(_at_)_polylogics_(_dot_)_com>]

I just installed OBSD 3.3 on my Sony Vaio PCG-GRX600P laptop and noticed
the  wireless  card  is  only  recognized  in one of the cardslots.

The  working dmesg is attached below, the only difference between it and
the  non-working  configuration is the last two lines where it discovers
and accepts wi0.

The  obvious  workaround is remembering to stick the card in the correct
slot but I'm curious about why this would happen.

Any ideas?

--- dmesg follows ---
OpenBSD 3.3 (GENERIC) #44: Sat Mar 29 13:22:05 MST 2003
    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium 4 ("GenuineIntel" 686-class) 1.99 GHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SIMD,3DNOW
real mem  = 535863296 (523304K)
avail mem = 491274240 (479760K)
using 4278 buffers containing 26894336 bytes (26264K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(9a) BIOS, date 08/01/02, BIOS32 rev. 0 @ 0xfd890
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xfd890/0x770
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xfdf50/144 (7 entries)
pcibios0: PCI Interrupt Router at 000:31:0 ("Intel 82371FB PCI-ISA" rev 0x00)
pcibios0: PCI bus #4 is the last bus
bios0: ROM list: 0xc0000/0x10000 0xd8000/0x4000! 0xdc000/0x4000!
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82845 Host" rev 0x04
ppb0 at pci0 dev 1 function 0 "Intel 82845 AGP" rev 0x04
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "ATI Radeon Mobility M7 LW" rev 0x00
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
uhci0 at pci0 dev 29 function 0 "Intel 82801CA/CAM USB" rev 0x02: irq 9
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1 at pci0 dev 29 function 1 "Intel 82801CA/CAM USB" rev 0x02: irq 9
usb1 at uhci1: USB revision 1.0
uhub1 at usb1
uhub1: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2 at pci0 dev 29 function 2 "Intel 82801CA/CAM USB" rev 0x02pci_intr_map: no mapping for pin C
: couldn't map interrupt
ppb1 at pci0 dev 30 function 0 "Intel 82801BAM Hub-to-PCI" rev 0x42
pci2 at ppb1 bus 2
cbb0 at pci2 dev 5 function 0 "Ricoh 5C476 PCI-CardBus" rev 0xa8: irq 3
cbb1 at pci2 dev 5 function 1 "Ricoh 5C476 PCI-CardBus" rev 0xa8pci_intr_map: no mapping for pin B
: couldn't map interrupt
"Ricoh 5C552 PCI-Firewire" rev 0x00 at pci2 dev 5 function 2 not configured
fxp0 at pci2 dev 8 function 0 "Intel PRO/100 VE" rev 0x42: irq 9, address 08:00:46:7a:17:9e
inphy0 at fxp0 phy 1: i82562ET 10/100 media interface, rev. 0
cardslot0 at cbb0 slot 0 flags 0
cardbus0 at cardslot0: bus 3 device 0 cacheline 0x0, lattimer 0x20
pcmcia0 at cardslot0
pcib0 at pci0 dev 31 function 0 "Intel 82801CAM LPC" rev 0x02
pciide0 at pci0 dev 31 function 1 "Intel 82801CAM IDE" rev 0x02: DMA, channel 0 configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <HITACHI_DK23EA-60>
wd0: 16-sector PIO, LBA, 57231MB, 16383 cyl, 16 head, 63 sec, 117210240 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
atapiscsi0 at pciide0 channel 1 drive 0
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <SONY, CD-RW CRX820E, 1.5k> SCSI0 5/cdrom removable
cd0(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
"Intel 82801CA/CAM SMB" rev 0x02 at pci0 dev 31 function 3 not configured
auich0 at pci0 dev 31 function 5 "Intel 82801CA/CAM AC97 Audio" rev 0x02: irq 9, ICH3 AC97
ac97: codec id 0x594d4803 (Yamaha <03>)
ac97: codec features 18 bit DAC, No 3D Stereo
audio0 at auich0
"Intel 82801CA/CAM Modem" rev 0x02 at pci0 dev 31 function 6 not configured
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
biomask c208 netmask c208 ttymask d28a
pctr: user-level cycle counter enabled
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
wi0 at pcmcia0 function 0 "Sony Corporation, PCWA-C150, Version 01.01" port 0xa000/64
wi0: Firmware 8.42 variant 1, address 00:02:2d:73:f2:c6

-- 
rodd_(_at_)_polylogics_(_dot_)_com     "The avalanche has already started, it is too
Rod Dorman              late for the pebbles to vote." ? Ambassador Kosh