[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Snapshot can't find CDROM on installation



Hi

I have installed a snapshot downloaded on last thirsday (may 22). I
created a bootable CD, which worked, but after partitioning, when I
said my install sets were on a CDROM, the install program couldn't
find it ("Done - no available CD-ROMs found").

I managed to install by copying the install sets to another HD and
mounting it before installing. And then everything went fine. Has
anyone  also found this behavior?

Below are the kernel messages from the bootable CD (which doesn't find
the CDROM drive) and the one after my install was completed:

--< boot cd >--
OpenBSD 3.3-current (RAMDISK_CD) #15: Wed May 21 06:57:55 MDT 2003
    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/RAMDISK_CD
cpu0: AMD Athlon Model 4 (Thunderbird) ("AuthenticAMD" 686-class) 908 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXS
R
real mem  = 133787648 (130652K)
avail mem = 118964224 (116176K)
using 1658 buffers containing 6791168 bytes (6632K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(c3) BIOS, date 07/12/01, BIOS32 rev. 0 @
0xf0e70
apm0 at bios0: Power Management spec V1.2
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0x16b2
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xf1620/144 (7 entries)
pcibios0: PCI Interrupt Router at 000:07:0 ("VIA VT82C586 PCI-ISA" rev
0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xa800
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA VT8363 Host" rev 0x81
ppb0 at pci0 dev 1 function 0 "VIA VT8363 PCI-AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "Nvidia Riva TNT2" rev 0x15
wsdisplay0 at vga1: console (80x25, vt100 emulation)
pcib0 at pci0 dev 7 function 0 "VIA VT82C686 PCI-ISA" rev 0x40
pciide0 at pci0 dev 7 function 1 "VIA VT82C571 IDE" rev 0x06: ATA100,
channel 0
configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <ST320413A>
wd0: 16-sector PIO, LBA, 19092MB, 16383 cyl, 16 head, 63 sec, 39102336
sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 5
wd1 at pciide0 channel 1 drive 0: <ST34321A>
wd1: 32-sector PIO, LBA, 4103MB, 8894 cyl, 15 head, 63 sec, 8404830
sectors
wd1(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "VIA VT83C572 USB" rev 0x16: irq 9
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1 at pci0 dev 7 function 3 "VIA VT83C572 USB" rev 0x16: irq 9
usb1 at uhci1: USB revision 1.0
uhub1 at usb1
uhub1: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
"VIA VT82C686 SMBus" rev 0x40 at pci0 dev 7 function 4 not configured
"Creative Labs SoundBlaster Live" rev 0x08 at pci0 dev 14 function 0
not configu
red
"Creative Labs SoundBlaster Live Digital Input" rev 0x08 at pci0 dev
14 function
 1 not configured
"US Robotics 3CP5610" rev 0x01 at pci0 dev 15 function 0 not configured
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask c240 netmask c240 ttymask c242
rd0: fixed, 3560 blocks
wd0: no disk label
root on rd0a
rootdev=0x1100 rrootdev=0x2f00 rawdev=0x2f02
---


--< installed system >--
OpenBSD 3.3-current (GENERIC) #26: Wed May 21 06:42:18 MDT 2003
    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD Athlon Model 4 (Thunderbird) ("AuthenticAMD" 686-class) 908 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXS
R
real mem  = 133787648 (130652K)
avail mem = 118185984 (115416K)
using 1658 buffers containing 6791168 bytes (6632K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(c3) BIOS, date 07/12/01, BIOS32 rev. 0 @
0xf0e70
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0x16b2
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xf1620/144 (7 entries)
pcibios0: PCI Interrupt Router at 000:07:0 ("VIA VT82C586 PCI-ISA" rev
0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xa800
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "VIA VT8363 Host" rev 0x81
ppb0 at pci0 dev 1 function 0 "VIA VT8363 PCI-AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "Nvidia Riva TNT2" rev 0x15
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pcib0 at pci0 dev 7 function 0 "VIA VT82C686 PCI-ISA" rev 0x40
pciide0 at pci0 dev 7 function 1 "VIA VT82C571 IDE" rev 0x06: ATA100,
channel 0
configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <ST320413A>
wd0: 16-sector PIO, LBA, 19092MB, 16383 cyl, 16 head, 63 sec, 39102336
sectors
atapiscsi0 at pciide0 channel 0 drive 1
scsibus0 at atapiscsi0: 2 targets
cd0 at scsibus0 targ 0 lun 0: <ATAPI, CD-ROM MARY500, 1.11> SCSI0
5/cdrom remova
ble
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
cd0(pciide0:0:1): using PIO mode 4, Ultra-DMA mode 2
wd1 at pciide0 channel 1 drive 0: <ST34321A>
wd1: 32-sector PIO, LBA, 4103MB, 8894 cyl, 15 head, 63 sec, 8404830
sectors
wd1(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "VIA VT83C572 USB" rev 0x16: irq 9
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1 at pci0 dev 7 function 3 "VIA VT83C572 USB" rev 0x16: irq 9
usb1 at uhci1: USB revision 1.0
uhub1 at usb1
uhub1: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
viaenv0 at pci0 dev 7 function 4 "VIA VT82C686 SMBus" rev 0x40
emu0 at pci0 dev 14 function 0 "Creative Labs SoundBlaster Live" rev
0x08: irq 1
0
ac97: codec id 0x83847609 (SigmaTel STAC9721/23)
ac97: codec features 18 bit DAC, 18 bit ADC, SigmaTel 3D
audio0 at emu0
"Creative Labs SoundBlaster Live Digital Input" rev 0x08 at pci0 dev
14 function
 1 not configured
puc0 at pci0 dev 15 function 0 "US Robotics 3CP5610" rev 0x01: com
pccom3 at puc0 port 0 irq 5: ns16550a, 16 byte fifo
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pms0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pms0 mux 0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask c240 netmask c240 ttymask d2c2
pctr: user-level cycle counter enabled
mtrr: Pentium Pro MTRR support
wd0: no disk label
dkcsum: wd0 matched BIOS disk 80
dkcsum: wd1 matched BIOS disk 81
root on wd1a
rootdev=0x10 rrootdev=0x310 rawdev=0x312
---

Thanks
Andre