[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: highpoint 366 and openbsd 3.2



Op di 17-12-2002, om 20:26 schreef Chuck Yerkes:
> I don't find a dmesg attached to this.
> Please read the FAQs about mail, or "man afterboot".
> 
> Quoting Patrick Barendregt (pbarendregt_(_at_)_amersfoort_(_dot_)_xs4all_(_dot_)_nl):
> > I'm using a pc i got from my father as a server with openbsd 3.2.
> > The problem is i had some crashes and all of them when i was moving (or
> > copying) data to on the harddisks in the system. Their are two one
> > maxtor and one ibm both udma 5. Because their is a onboard hpt366
> >controller i thought to use this one but after 2 or three crashes 
> >with the following error 

> >wd0(pciide1:0:): timeout
> >type: ata
> >c_bcount: 65536
> > C_skip: 0
> > pciide1:0:0: bus-master DMA error missing interrupt, status=0x21

> >After the last crash it wouldn't boot anymore so i put the disks to >
> >the "normal" ide controller and now they seem to work but they are a
> >lot slower.
> > I got two questions:
> > 1 Am i right to blaim those onboard hpt366 controllers ?
> >2 In my client pc (running suse 8.0) i use a promisse tx controller >
> isthat a good controller to run with openbsd 3.2 ??



I did not add the dmesg because i thought it wasn't needed because the
hardisks are not connected to the hpt366 controller anymore..
But here it is..

PS please reply next to the complete post now i add the cut and paste the questions back in.

thnx

-- 

Patrick Barendregt <pbarendregt_(_at_)_amersfoort_(_dot_)_xs4all_(_dot_)_nl>
OpenBSD 3.2 (GENERIC) #25: Thu Oct  3 19:51:53 MDT 2002
    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium III ("GenuineIntel" 686-class, 512KB L2 cache) 464 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SIMD
real mem  = 133804032 (130668K)
avail mem = 118460416 (115684K)
using 1658 buffers containing 6791168 bytes (6632K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(8b) BIOS, date 07/05/00, BIOS32 rev. 0 @ 0xfb350
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0xb7d8
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xfdef0/160 (8 entries)
pcibios0: PCI Exclusive IRQs: 11
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371SB PCI-ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0x8000 0xc8000/0x200!
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82443BX PCI-AGP" rev 0x03
ppb0 at pci0 dev 1 function 0 "Intel 82443BX AGP" rev 0x03
pci1 at ppb0 bus 1
pcib0 at pci0 dev 7 function 0 "Intel 82371AB PIIX4 ISA" rev 0x02
pciide0 at pci0 dev 7 function 1 "Intel 82371AB IDE" rev 0x01: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <IC35L040AVER07-0>
wd0: 16-sector PIO, LBA, 39266MB, 16383 cyl, 16 head, 63 sec, 80418240 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
wd1 at pciide0 channel 1 drive 0: <IC35L060AVER07-0>
wd1: 16-sector PIO, LBA, 58644MB, 16383 cyl, 16 head, 63 sec, 120103200 sectors
wd1(pciide0:1:0): using PIO mode 4, Ultra-DMA mode 2
uhci0 at pci0 dev 7 function 2 "Intel 82371AB USB" rev 0x01: irq 11
usb0 at uhci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
"Intel 82371AB Power Mgmt" rev 0x02 at pci0 dev 7 function 3 not configured
rl0 at pci0 dev 11 function 0 "Realtek 8139" rev 0x10: irq 11 address 00:50:bf:65:91:88
rlphy0 at rl0 phy 0: RTL internal phy
vga1 at pci0 dev 15 function 0 "Alliance Semiconductor AT24" rev 0x00
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pciide1 at pci0 dev 19 function 0 "HighPoint HPT36x/37x IDE" rev 0x01: DMA
pciide1: using irq 11 for native-PCI interrupt
pciide2 at pci0 dev 19 function 1 "HighPoint HPT36x/37x IDE" rev 0x01: DMA
pciide2: using irq 11 for native-PCI interrupt
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
ep0 at isa0 port 0x300/16 irq 5: address 00:60:97:e3:8f:1e, utp/aui (default utp)
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask c840 netmask c860 ttymask d8e2
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
dkcsum: wd0 matched BIOS disk 80
dkcsum: wd1 matched BIOS disk 81
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302



Visit your host, monkey.org