[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

an0 problems with 3.2-stable



I just had the network lockup on a 3.2 box. Unfortunately I had no console near it to troubleshoot while it was still up. Upon re-boot I have the following lines in /var/log/messages right before the lockup. Also, going back to 2.9-stable I get "an0: failed to enable MAC" messages on boot-up.

root_(_at_)_oats:/var/log# tail -150 /var/log/messages
...
Nov 21 23:26:14 oats /bsd: an0: failed to allocate 1586 bytes on NIC
Nov 21 23:26:14 oats /bsd: an0: tx buffer allocation failed
...

If it makes any difference the above happened while I was setting up nfsd on this system. I'm having a little trouble so I ran tcpdump -i an0 right before it locked up. I'll give it a shot again later, if need be.

ethant_(_at_)_oats:/home/ethant# cat /etc/hostname.an0
inet 192.168.1.1 255.255.255.0 NONE
!ancontrol -o 0 -K 0 -j 1000 -n home
!route add 192.168.2.0 192.168.1.11


OpenBSD 3.2-stable (GENERIC) #2: Fri Nov 15 15:14:38 PST 2002
ethant_(_at_)_oats_(_dot_)_2fortheroad_(_dot_)_net:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: F00F bug workaround installed
cpu0: Intel Pentium (P54C) ("GenuineIntel" 586-class) 134 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,MCE,CX8
real mem = 66695168 (65132K)
avail mem = 56303616 (54984K)
using 839 buffers containing 3436544 bytes (3356K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(95) BIOS, date 03/25/97, BIOS32 rev. 0 @ 0xfb660
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0xbb24
pcibios0: PCI BIOS has 6 Interrupt Routing table entries
pcibios0: PCI Interrupt Router at 000:07:0 ("Intel 82371SB PCI-ISA" rev 0x00)
pcibios0: PCI bus #0 is the last bus
bios0: ROM list: 0xc0000/0x8000
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Intel 82439HX" rev 0x03
pcib0 at pci0 dev 7 function 0 "Intel 82371SB PCI-ISA" rev 0x01
pciide0 at pci0 dev 7 function 1 "Intel 82371SB IDE" rev 0x00: DMA, channel 0 wi
red to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <ST32520A>
wd0: 16-sector PIO, LBA, 2405MB, 4888 cyl, 16 head, 63 sec, 4927104 sectors
wd1 at pciide0 channel 0 drive 1: <ST32132A>
wd1: 16-sector PIO, LBA, 2015MB, 4095 cyl, 16 head, 63 sec, 4127760 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2
wd1(pciide0:0:1): using PIO mode 4, DMA mode 2
xl0 at pci0 dev 13 function 0 "3Com 3c905B 100Base-TX" rev 0x00: irq 11 address
00:10:5a:02:3d:8f
exphy0 at xl0 phy 24: 3Com internal media interface
an0 at pci0 dev 15 function 0 "Aironet Cisco/Aironet PCI35x WLAN" rev 0x01: irq
10: address 00:07:0e:b9:2f:07
vga1 at pci0 dev 16 function 0 "ATI Mach64 VT" rev 0x40
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 4040 netmask 4c40 ttymask 4cc2
pctr: 586-class performance counters and user-level cycle counter enabled
dkcsum: wd0 matched BIOS disk 80
dkcsum: wd1 matched BIOS disk 81
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
WARNING: / was not properly unmounted
an0: failed to enable MAC
an0: failed to enable MAC
an0: failed to enable MAC




Visit your host, monkey.org