Re: Anyway to get 3.2 to run with an Adaptec 2940UW controller?

[Anthony Schlemmer <aschlemm_(_at_)_attbi_(_dot_)_com>]

I did get a reply via email and it was suggested to me that I make sure 
I don't have a SCSI disk with an ID of 0 on it. I changed the ID on my 
system's internal SCSI disk to 1 and "fsck" was able to repair the 
filesystems and the system booted all the way up into multi-user mode.

I haven't tried accessing the SCSI CDROM drive again but I guess I'll 
give it a try and see what happens.

Tony

On Saturday 16 November 2002 21:52 pm, Anthony Schlemmer wrote:
> Well I seemed to have screwed the pooch and hosed my new install of
> OBSD 3.2 on my system that has an Adaptec 2940UW controller. This is
> a bit of a shock as the Adaptec controller worked fine with OBSD 3.1.
>
> I got OBSD it installed via FTP and I thought I'd save time and
> install the source from the CDROM set. As soon as my system accessed
> the CDROM it crashed and I was staring at ddb prompt. I'm now stuck
> unable to boot the system as the system seems to crash during the
> fsck since the filesystems weren't unmounted cleanly because of my
> earlier crash.
>
> Any suggestions or am I out of luck for now getting 3.2 installed on
> my system?
>
> Thanks,
>
> Tony

-- 
Anthony Schlemmer
aschlemm_(_at_)_attbi_(_dot_)_com