i386 dmesg for snapshot 2/8/2002

[Diana Eichert <deichert_(_at_)_wrench_(_dot_)_com>]

i installed the 2/8/2002 i386 snapshot successfully after finding out the
install floppy was missing the rd0 device, used the 3.0 install floppy
instead.

this problem was resolved in the 2/9/2002 install floppy.

dmesg follows and was sent to dmesg_(_at_)_openbsd_(_dot_)_org in previous e-mail


---------- Forwarded message ----------

    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD Athlon Model 4 (Thunderbird) ("AuthenticAMD" 686-class) 1.34 GHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SYS,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR
real mem  = 502824960 (491040K)
avail mem = 460410880 (449620K)
using 5689 buffers containing 25243648 bytes (24652K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(9e) BIOS, date 07/25/01, BIOS32 rev. 0 @ 0xf1070
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0x1872
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xf17e0/144 (7 entries)
pcibios0: PCI Interrupt Router at 000:01:0 ("SIS 85C503 ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0xc000 0xcc000/0x800
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "SIS 730 Host-PCI" rev 0x02
pciide0 at pci0 dev 0 function 1 "SIS 5513 EIDE" rev 0xd0: DMA, channel 0 wired to compatibility, channel 1 wired to compatibility
wd0 at pciide0 channel 0 drive 0: <WDC WD600BB-00CFC0>
wd0: 16-sector PIO, LBA, 57241MB, 16383 cyl, 16 head, 63 sec, 117231408 sectors
wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 2
drive at pciide0 channel 1 drive 0 not configured
pcib0 at pci0 dev 1 function 0 "SIS 85C503 ISA" rev 0x00
ohci0 at pci0 dev 1 function 2 "SIS 5597/5598 USB" rev 0x07: irq 5, OHCI version 1.0, legacy support
usb0 at ohci0: USB revision 1.0
uhub0 at usb0
uhub0: vendor 0x0000 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 3 ports with 3 removable, self powered
ohci1 at pci0 dev 1 function 3 "SIS 5597/5598 USB" rev 0x07: irq 5, OHCI version 1.0, legacy support
usb1 at ohci1: USB revision 1.0
uhub1 at usb1
uhub1: vendor 0x0000 OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 3 ports with 3 removable, self powered
autri0 at pci0 dev 1 function 4 "SIS Trident 4D WAVE" rev 0x02: irq 10
ac97: codec id 0x414c4710 (Avance Logic ALC200)
ac97: codec features headphone, 18 bit DAC, 18 bit ADC, Realtek 3D
audio0 at autri0
midi0 at autri0: <4DWAVE MIDI UART>
ppb0 at pci0 dev 2 function 0 "SIS 86C201 Host-AGP" rev 0x00
pci1 at ppb0 bus 1
vga1 at pci1 dev 0 function 0 "SIS 6300" rev 0x31
wsdisplay0 at vga1: console (80x25, vt100 emulation)
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
rl0 at pci0 dev 9 function 0 "Realtek 8139" rev 0x10: irq 5 address 00:e0:18:25:f4:45
rlphy0 at rl0 phy 0: RTL internal phy
twe0 at pci0 dev 14 function 0 "3ware Escalade IDE RAID" rev 0x01: irq 10
twe0: Escalade V1.3
scsibus0 at twe0: 16 targets
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard, using wsdisplay0
pmsi0 at pckbc0 (aux slot)
pckbc0: using irq 12 for aux slot
wsmouse0 at pmsi0 mux 0
pcppi0 at isa0 port 0x61
midi1 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 4460 netmask 4460 ttymask 54e2
pctr: user-level cycle counter enabled
mtrr: Pentium Pro MTRR support
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302