Re: dc0 not working.

[michael_(_at_)_zaphod_(_dot_)_rhein-neckar_(_dot_)_de (Michael Lestinsky)]

Henning Brauer <lists-openbsd_(_at_)_bsws_(_dot_)_de> wrote:

>> dc0 at pci0 dev 11 function 0 "DEC DECchip 21142/3" rev 0x41: irq 11
>> address 00:00:cb:56:1a:96
>> OUI 0x00057d model 0x0003 rev 0 at dc0 phy 5 not configured
>> dcphy0 at dc0 phy 31: internal PHY
> 
> Hmm, odd. the OUI ... line suggests there is an unsupported PHY, the next
> line says there is a dcphy.

Hmm. I tried what Grigoriy suggested, that didn't help, still the same.

>> dc0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
>>         media: Ethernet none (100baseTX)
>>         status: no carrier
>>         inet 192.168.1.2 netmask 0xffffff00 broadcast 192.168.1.255
> 
> Autonegotiation failed.
> 
> ifconfig dc0 media 100BaseTX mediaopt full-duplex 

Well, I need it at half-duplex. The NIC is attached to an stupid 100-only
hub. And if dc(4) is correct then half-duplex is the default.

Doing an 'ifconfig dc0 media autoselect' fails completly, it doesn't even
set the NIC to 100baseTX.

Bye
Michael