[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Problems with Adaptec 2940U on 2.8-current



Hello,

I have quite a few problems with my OpenBSD box that has a PCI Adaptec
2940U scsi card in it.  When the machine boots, I get the following on
my terminal:

---cut---
ahc0 at pci0 dev 11 function 0 "Adaptec AHA-2940U" rev 0x00: irq 10
ahc0: Wide Channel A, SCSI Id=7, 16/255 SCBs
scsibus1 at ahc0: 16 targets
ahc0: board is not responding
cmd fail
probe(ahc0:0:0): SCB 0x1d - timed out in Message-out phase, SEQADDR == 0x155
probe(ahc0:0:0): BDR message in message buffer
sd0 at scsibus1 targ 0 lun 0: <, , > SCSI0 0/direct fixed
sd0: drive offline
---cut---

and it sits there for a while, then continue to boot.  I only have a
CDRW drive on that controller.  That machine used to run FreeBSD, and I
noticed that the driver waited 15 seconds for the drives to settle, then
continue to proceed.  If I tried to reduce the time it waited, I had
about the same results as I now have with OpenBSD.

I'm running 2.8-current as of April 7th.

Anyone has an idea ?

Ciao,
  ...David

-- 
// david lebel <lebel_(_at_)_lebel_(_dot_)_org>       // nobiaze' Inc.
// http://www.lebel.org/               // http://www.nobiaze.com/
// pgp: 3633 6999 D47E 73ED 099F       // vox: (514) 943.3045
        4341 08A4 8E48 EF56 61D1       // fax: (514) 938.8881

Attachment: pgp1kAvNFqs6X.pgp
Description: PGP signature


Visit your host, monkey.org