[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Problem recognizing D-Link DFE530TX



hi,

	i have a PC (P100) running OpenBSD with two NICs, a 3Com 3c905 & a
D-Link DFE530TX. when the system boots up, it complains about the DLink
card. however the documentation mentions that the card is supported.

	i have included the dmesg output below. 

	what could be the problem?

	thanks,

- bhaskar

P.S.: printed on the NIC - D-Link DFE-530TX REV-A1

---- dmesg output ---- 
OpenBSD 2.4 (GENERIC) #56: Thu Oct 22 01:26:52 MDT 1998
    deraadt_(_at_)_i386_(_dot_)_openbsd_(_dot_)_org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: F00F bug workaround installed
cpu0: Intel Pentium (P54C) ("GenuineIntel" 586-class) 100 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,MCE,CX8
BIOS mem  = 654336 conventional, 15728640 extended
real mem  = 16384000
avail mem = 11948032
using 225 buffers containing 921600 bytes of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(00) BIOS, date 10/13/95
bios0: pciinfo 0xf046a00c apminfo 0xf046a028 diskinfo 0xf046a050 cksumlen
1 memmap 0xf046a0cc
apm0 at bios0: Power Management spec V1.1
apm0: AC on, no battery
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "Intel 82437FX (Triton) PCI, Cache, and
DRAM Controller" rev 0x02
pcib0 at pci0 dev 7 function 0 "Intel 82371FB (Triton) PCI-ISA Bridge" rev
0x02
"S3 Trio32/64" rev 0x00 at pci0 dev 8 function 0 not configured
xl0 at pci0 dev 17 function 0 "3Com 3c905 100Base-TX" rev 0x00: irq 9
address 00:60:08:48:23:cb
xl0: autoneg complete, link status good (half-duplex, 10Mbps)
vendor "VIA Technologies", unknown product 0x3043 (class network, subclass
ethernet, rev 0x06) at pci0 dev 19 function 0 not configured
isa0 at mainbus0
lpt2 at isa0 port 0x3bc-0x3bf: polled
isadma0 at isa0
wdc0 at isa0 port 0x1f0-0x1f7 irq 14
atapibus0 at wdc0
acd0 at atapibus0 drive 1: <CDA46803I, F1.10000CDA46803I> ATAPI 5/cdrom
removable
wd0 at wdc0 drive 0: <Maxtor 71336 AP>
wd0: 1277MB, 2595 cyl, 16 head, 63 sec, 512 bytes/sec, 2616240 sec total
wd0: using 16-sector 16-bit pio transfers, lba addressing (128KB cache)
npx0 at isa0 port 0xf0-0xff: using exception 16
pccom0 at isa0 port 0x3f8-0x3ff irq 4: ns16550a, 16 byte fifo
pccom1 at isa0 port 0x2f8-0x2ff irq 3: ns16550a, 16 byte fifo
vt0 at isa0 port 0x60-0x6f irq 1: S3 764 (Trio64), 80 col, color, 8 scr,
mf2-kbd
pms0 at vt0 irq 12
fdc0 at isa0 port 0x3f0-0x3f5 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 4040 netmask 4240 ttymask 5242
root on wd0a
pctr: 586-class performance counters and user-level cycle counter enabled
dkcsum: wd0 matched BIOS disk 80
rootdev=0x0 rrootdev=0x300 rawdev=0x302
---- end of dmesg output ----

-- 
bhaskar_(_at_)_siliconsystems_(_dot_)_co_(_dot_)_in




Visit your host, monkey.org