[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: More kernel testing on lots of machines urgenetly needed!



hi,
i386;OpenBSD 3.5-current (GENERIC) #33: Wed Jun  9 12:40:16 MDT 2004;ppro200,256meg;boots ok, but see below
i386;OpenBSD 3.5-current (GENERIC.MP) #18: Wed Jun  9 12:40:26 MDT 2004;hw as in dmesg;
ahc fucks around

the machine is a hp netserver LH Pro. It's actually a Dual-CPU board w/
only one CPU equipped - the BIOS should hide this, tho (it says so.... )

booting hd0a:/bsd.mp.i386: 4877816+861624 [58+225392+203454]=0x5e20b8
entry point at 0x100120

[ using 429320 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
        The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-2004 OpenBSD. All rights reserved.  http://www.OpenBSD.org

OpenBSD 3.5-current (GENERIC.MP) #18: Wed Jun  9 12:40:26 MDT 2004
    deraadt@cvs.openbsd.org:/home/staff/deraadt/src/sys/arch/i386/compile/GENERIC.MP
cpu0: Intel Pentium Pro ("GenuineIntel" 686-class, 256KB L2 cache) 199 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV
real mem  = 268017664 (261736K)
avail mem = 239812608 (234192K)
using 3297 buffers containing 13504512 bytes (13188K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(48) BIOS, date 12/11/96, BIOS32 rev. 0 @ 0xf5d57
pcibios0 at bios0: rev. 2.1 @ 0xf5b70/0x1120
pcibios0: PCI BIOS has 8 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 11 15
pcibios0: no compatible PCI ICU found
pcibios0: Warning, unable to fix up PCI interrupt routing
pcibios0: PCI bus #1 is the last bus
bios0: ROM list: 0xc0000/0x8000 0xc8000/0x4000
mainbus0: Intel MP Specification (Version 1.1) (HP       LH Pro      )
cpu0 at mainbus0: apid 0 (boot processor)
cpu0: Intel Pentium Pro ("GenuineIntel" 686-class, 256KB L2 cache) 199 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV
cpu0: calibrating local timer
cpu0: apic clock running at 66 MHz
mpbios: bus 0 is type PCI   
mpbios: bus 1 is type PCI   
mpbios: bus 2 is type EISA  
ioapic0 at mainbus0 apid 1 (I/O APIC)
ioapic0: pa 0xfec00000, version 11, 16 pins
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Intel 82441FX" rev 0x02
ppb0 at pci0 dev 8 function 0 "DEC 21052 PCI-PCI" rev 0x02
pci1 at ppb0 bus 1
fxp0 at pci1 dev 2 function 0 "Intel 82557" rev 0x05pci_intr_map: bus 1 dev 2 func 0 pin 1; line 11
pci_intr_map: no MP mapping found
isa_intr_establish: no MP mapping found
: irq 11, address 00:90:27:4d:15:85
inphy0 at fxp0 phy 1: i82555 10/100 media interface, rev. 0
"Intel 82375EB EISA" rev 0x15 at pci0 dev 9 function 0 not configured
ahc1 at pci0 dev 10 function 0 "Adaptec AIC-7880" rev 0x00pci_intr_map: bus 0 dev 10 func 0 pin 1; line 15
pci_intr_map: no MP mapping found
isa_intr_establish: no MP mapping found
: irq 15
ahc1: Using left over BIOS settings
scsibus0 at ahc1: 16 targets
sd0 at scsibus0 targ 0 lun 0: <SEAGATE, ST318275LC, 0001> SCSI2 0/direct fixed
sd0: 17366MB, 11721 cyl, 10 head, 303 sec, 512 bytes/sec, 35566480 sec total
sd1 at scsibus0 targ 1 lun 0: <SEAGATE, ST318275LC, 0001> SCSI2 0/direct fixed
sd1: 17366MB, 11721 cyl, 10 head, 303 sec, 512 bytes/sec, 35566480 sec total
sd2 at scsibus0 targ 3 lun 0: <SEAGATE, ST318275LC, 0001> SCSI2 0/direct fixed
sd2: 17366MB, 11721 cyl, 10 head, 303 sec, 512 bytes/sec, 35566480 sec total
cd0 at scsibus0 targ 5 lun 0: <TOSHIBA, CD-ROM XM-5401TA, 3115> SCSI2 5/cdrom removable
st0 at scsibus0 targ 6 lun 0: <HP, C1537A, U812> SCSI2 1/sequential removable
st0: drive empty
ch0 at scsibus0 targ 6 lun 1: <HP, C1557A, U812> SCSI2 8/changer removable
ahc2 at pci0 dev 11 function 0 "Adaptec AIC-7880" rev 0x00pci_intr_map: bus 0 dev 11 func 0 pin 1; line 15
pci_intr_map: no MP mapping found
isa_intr_establish: no MP mapping found
: irq 15
ahc2: Using left over BIOS settings
scsibus1 at ahc2: 16 targets
eisa0 at mainbus0
eisa0: can't map I/O space for slot 14
eisa0: can't map I/O space for slot 15
isa0 at mainbus0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
isa_intr_establish: no MP mapping found
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
vga0 at isa0 port 0x3b0/48 iomem 0xa0000/131072
wsdisplay0 at vga0: console (80x25, vt100 emulation), using wskbd0
wsdisplay0: screen 1-5 added (80x25, vt100 emulation)
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
lpt0 at isa0 port 0x378/4 irq 7
isa_intr_establish: no MP mapping found
npx0 at isa0 port 0xf0/16: using exception 16
pccom0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
isa_intr_establish: no MP mapping found
pccom0: console
pccom1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
isa_intr_establish: no MP mapping found
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
isa_intr_establish: no MP mapping found
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask f765 netmask ff65 ttymask ffe7
ioapic0: enabling
pctr: 686-class user-level performance counters enabled
mtrr: Pentium Pro MTRR support
ahc1: Timedout SCB already complete. Interrupts may not be functioning.
sd0(ahc1:0:0): SCB 0xf - timed out
>>>>>>>>>>>>>>>>>> Dump Card State Begins <<<<<<<<<<<<<<<<<
ahc1: Dumping Card State in Message-out phase, at SEQADDR 0xe7
Card was paused
ACCUM = 0xa0, SINDEX = 0x61, DINDEX = 0xc0, ARG_2 = 0x3
HCNT = 0x0 SCBPTR = 0x0
SCSISIGI[0xb6] ERROR[0x0] SCSIBUSL[0x20] LASTPHASE[0xa0] 
SCSISEQ[0x12] SBLKCTL[0x2] SCSIRATE[0x0] SEQCTL[0x10] 
SEQ_FLAGS[0x40] SSTAT0[0x7] SSTAT1[0x3] SSTAT2[0x0] 
SSTAT3[0x0] SIMODE0[0x0] SIMODE1[0xac] SXFRCTL0[0x88] 
DFCNTRL[0x4] DFSTATUS[0x6d] 
STACK: 0x0 0x16a 0x19a 0xe5
SCB count = 16
Kernel NEXTQSCB = 14
Card NEXTQSCB = 14
QINFIFO entries: 
Waiting Queue entries: 
Disconnected Queue entries: 
QOUTFIFO entries: 
Sequencer Free SCB List: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 
Sequencer SCB Info: 
  0 SCB_CONTROL[0x60] SCB_SCSIID[0x7] 
SCB_LUN[0x0] SCB_TAG[0xf] 
  1 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  2 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  3 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  4 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  5 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  6 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  7 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  8 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
  9 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 10 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 11 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 12 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 13 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 14 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
 15 SCB_CONTROL[0x0] SCB_SCSIID[0xff] 
SCB_LUN[0xff] SCB_TAG[0xff] 
Pending list: 
 15 SCB_CONTROL[0x60] SCB_SCSIID[0x7] 
SCB_LUN[0x0] 
Kernel Free SCB list: 13 12 11 10 9 8 7 6 5 4 3 2 1 0 
FEATURES = 0x4, FLAGS = 0x481440, CHIP = 0x407 BUGS =0x25

<<<<<<<<<<<<<<<<< Dump Card State Ends >>>>>>>>>>>>>>>>>>
sg[0] - Addr 0x6e5eac : Length 44
sd0(ahc1:0:0): BDR message in message buffer
sd0(ahc1:0:0): SCB 0xf - timed out
>>>>>>>>>>>>>>>>>> Dump Card State Begins <<<<<<<<<<<<<<<<<
(loops from here the same dump over and over again - resetted it after 15mins)



-- 
pb@