Hello,
I think the problems reported earlier were NOT caused by my
aha controller, but rather by the faulty IDE controller on
the mainboard. My apologies; the aha driver seems ok.
Now CTM hung extracting a file got by ftp from wd0 to wd0;
this chance I took to download the latest kernel snapshot
and post this dmesg.
[ wd0 on pciide0: flags 0x0ff0 instead of 0x0000
because else I got instant soft errors and downgrading
messages, although the HDD is fairly new and good ]
OpenBSD 3.1-current (GENERIC) #20: Sun Jul 7 16:44:52 MDT 2002
deraadt@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: AMD K6-2 ("AuthenticAMD" 586-class) 301 MHz
cpu0: FPU,V86,DE,PSE,TSC,MSR,MCE,CX8,PGE,MMX
real mem = 268021760 (261740K)
avail mem = 242663424 (236976K)
using 3297 buffers containing 13504512 bytes (13188K) of memory
mainbus0 (root)
bios0 at mainbus0: AT/286+(20) BIOS, date 02/05/01, BIOS32 rev. 0 @ 0xfb530
apm0 at bios0: Power Management spec V1.2
apm0: AC on, battery charge unknown
pcibios0 at bios0: rev. 2.1 @ 0xf0000/0xb9b8
pcibios0: PCI IRQ Routing Table rev. 1.0 @ 0xfdef0/128 (6 entries)
pcibios0: PCI Exclusive IRQs: 10 12 15
pcibios0: PCI Interrupt Router at 000:07:0 ("Acer Labs M1543 PCI-ISA" rev 0x00)
pcibios0: PCI bus #1 is the last bus
pci0 at mainbus0 bus 0: configuration mode 1 (no bios)
pchb0 at pci0 dev 0 function 0 "Acer Labs M1541 Host-PCI" rev 0x04
ppb0 at pci0 dev 1 function 0 "Acer Labs M5243 AGP/PCI-PCI" rev 0x04
pci1 at ppb0 bus 1
pcib0 at pci0 dev 7 function 0 "Acer Labs M1543 PCI-ISA" rev 0xb4
pciide0 at pci0 dev 15 function 0 "Acer Labs M5229 UDMA IDE" rev 0x20: DMA, channel 0 configured to compatibility, channel 1 configured to compatibility
wd0 at pciide0 channel 0 drive 0: <Maxtor 32049H2>
wd0: 16-sector PIO, LBA, 19073MB, 16383 cyl, 16 head, 63 sec, 39062500 sectors
wd0(pciide0:0:0): using PIO mode 4
pciide0: channel 1 ignored (disabled)
de0 at pci0 dev 18 function 0 "DEC 21040" rev 0x23: irq 10
de0: Cogent 21040 [10Mb/s] pass 2.3 address 00:00:92:91:0e:2b
xl0 at pci0 dev 20 function 0 "3Com 3c905B 100Base-TX" rev 0x24: irq 15 address 00:a0:24:a8:15:2b
exphy0 at xl0 phy 24: 3Com internal media interface
isa0 at pcib0
isadma0 at isa0
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pcdisplay0 at isa0 port 0x3b0/16 iomem 0xb0000/32768
wsdisplay0 at pcdisplay0: console (80x25, vt100 emulation), using wskbd0
(bha probe): bha_cmd, cmd/data port empty 13
aha0 at isa0 port 0x330/4 irq 11 drq 5: model AHA-1542C, firmware 0.1
aha0: unlocking mailbox interface
aha0: async, parity
scsibus0 at aha0: 8 targets
cd0 at scsibus0 targ 2 lun 0: <PLEXTOR, CD-ROM PX-32TS, 1.01> SCSI2 5/cdrom removable
pcppi0 at isa0 port 0x61
midi0 at pcppi0: <PC speaker>
sysbeep0 at pcppi0
npx0 at isa0 port 0xf0/16: using exception 16
fdc0 at isa0 port 0x3f0/6 irq 6 drq 2
fd0 at fdc0 drive 0: 1.44MB 80 cyl, 2 head, 18 sec
biomask 4840 netmask cc40 ttymask cc42
pctr: user-level cycle counter enabled
mtrr: K6-family MTRR support (2 registers)
dkcsum: wd0 matched BIOS disk 80
root on wd0a
rootdev=0x0 rrootdev=0x300 rawdev=0x302
de0: enabling 10baseT port