[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Booting OpenBSD on Mac IIci



I've been attempting to boot OpenBSD on Mac IIci without success as 
you can see from the below kernal boot messages. The booting process 
ends with the message "slot_noint() slot d " endlessly repeated. 
Where upon I hit the reset button. I get the same result with the 
Daystar card removed. I tried removing both the Daystar and video 
card (using built-in video) Here the screen fills with vertical lines 
and no messages displayed. Any help on what to do next would be 
appreciated.

System Configuration:
Mac IIci with Daystar Turbo 040 33Mhz (ROM v4.11)
(2) Farallon EtherMac II-TP in slot A,C
Radius PrecisionColor 24xp video card, slot B
External Hard Disk and DDS-2 tape drive connected to scsi

OpenBSD was installed from the 2.5 CDRom with the following files:
BASE25_T.GZ
bsd-generic.tar.gz
COMP25_T.GZ
ETC25_TA.GZ
GAME25_T.GZ
MAN25_TA.GZ
MISC25_T.GZ
XBASE25_.GZ
XFONT25_.GZ
XSERV25_.GZ
XSHARE25.GZ

[ preserving 333122 bytes of bsd symbol table ]
Bootstrapping OpenBSD/mac68k.
Faked range to byte 0x2000000.
Bootstrapping the pmap system.
Pmap bootstrapped.
Moving ROMBase from 0x40800000 to 0xcd3000.
Video address 0xfd000000 -> 0xed3000.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California.  All rights reserved.
Copyright (c) 1995-1999 OpenBSD. All rights reserved.  http://www.OpenBSD.org
 
OpenBSD 2.5 (GENERIC) #2: Thu Apr 15 06:17:50 MDT 1999
     root@tinkywinky:/usr/src/sys/arch/mac68k/compile/GENERIC
Apple Macintosh IIci  (68040)
cpu: delay factor 388
real mem = 33554432
avail mem = 29147136
using 204 buffers containing 835584 bytes of memory
mrg: 'Mac IIci/Q700 ROMs' ROM glue, tracing off, debug off, silent traps
mrg: I/O map kludge for ROMs that use hardware addresses directly.
adb: bus subsystem
Got following HwCfgFlags: 0xfc00, 0x    773f, 0x       0, 0x       0
mrg: skipping egret setup
adb: calling ADBReInit
adb: using II series hardware support
adb: cleanup: nothing returned
adb: ADBReInit complete
adb: extended keyboard at 2
adb: 100 dpi mouse at 3
mainbus0 (root)
obio0 at mainbus0
adb0 at obio0 (ADB event device)
asc0 at obio0: Apple Sound Chip
ncrscsi0 at obio0
scsibus0 at ncrscsi0: 8 targets
sd0 at scsibus0 targ 0 lun 0: <QUANTUM, LPS540S, 5900> SCSI2 0/direct fixed
sd0: 516MB, 2740 cyl, 4 head, 96 sec, 512 bytes/sec, 1057616 sec total
st0 at scsibus0 targ 3 lun 0: <ARCHIVE, Python 28388-XXX, 4.28> SCSI2 
1/sequenti
al removable
st0: density code 0x13, 512-byte blocks, write-enabled
sd1 at scsibus0 targ 5 lun 0: <IBM, DPES-31080, S31K> SCSI1 0/direct fixed
sd1: 1034MB, 4903 cyl, 4 head, 108 sec, 512 bytes/sec, 2118144 sec total
zsc0 at obio0 chip type 0
zstty0 at zsc0 channel 0
zstty1 at zsc0 channel 1 (console) (raw defaults)
nubus0 at mainbus0
ae0 at nubus0: address 00:00:00:00:00:00, type Farallon EtherMac 
II-TP, 32KB mem
ory
macvid0 at nubus0: Radius PrecisionColor 24Xp Series
macvid0: Unknown video card 0x406--Not installing interrupt routine.
macvid0: 640 x 480, monochrome
grf0 at macvid0
ite0 at grf0 (minimal console)
ae1 at nubus0: address 00:00:00:00:00:00, type Farallon EtherMac 
II-TP, 32KB mem
ory
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d
slot_noint() slot d