bug in the sparc release, quad ethernet

["andreas loong" <regulators_net@yahoo.com>]

Hi,

Just installed 2.7 here. The machine is a sparcstation5 110Mhz.
It was intended to be my main router to the outside world.
Everything installed nicely, except the qe[0-3] device drivers.
It kept complaining about 'File exists' and when I rebooted, it went 
into kernel debug mode. Unfortunately, I'm not a coder..

this is what it says just before it goes into the ddb.

ledma at sbus0 slot 5 offset 0x8400010: rev 2
le0 at ledma0 offset 0x8c00000 pri 6: address 08:00:20:94:6e:72
le0: 16 receive buffers, 4 transmit buffers
audiocs0 at sbus0 slot 4 offset 0xc000000 pri 9 softpri 4
audio0 at audiocs0
power-management at sbus0 slot 4 offset 0xa000000 not 
configured 
qec0 at sbus0 slot 1 offset 0x20000: 129L memory 4 channels
qe0 at qec0 offset 0x10000 pri 7: rev 1 address 08:00:20:94:6e:72
qe1 at qec0 offset 0x14000 pri 7: rev 1 address 08:00:20:94:6e:72
qe2 at qec0 offset 0x18000 pri 7: rev 1 address 08:00:20:94:6e:72
qe3 at qec0 offset 0x1c000 pri 7: rev 1 address 08:00:20:94:6e:72
root on sd0a
rootdev=0x700 rrootdev=0x1100 rawdev=0x1102
setting tty flags
starting network
NMI: system interrupts:
panic: nmi
Stopped at		_Debugger+0x4:	jmpl	[%o7 + 0x8], %g0
ddb>

Anything I can do to help you guys solve this one?
I really want openbsd as my router, and if this is an error not seen 
before..

Best regards,
Andreas Loong

_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com