Re: X Can't "see" my docked monitor - xorg or nvidia?

[Doug Barton <dougb_(_at_)_FreeBSD_(_dot_)_org>]

Thanks for responding, sorry it took so long to get back to you, 
$REAL_LIFE is in my face lately.

I was able to remove kde from the equation by starting good old 
windowmaker, same results.

On Wed, 7 Nov 2007, Anton Berezin wrote:

> On Tue, Nov 06, 2007 at 01:19:18PM -0800, Doug Barton wrote:
> > I just did the mondo upgrade of the ports on my up to date 8-current
> > laptop. Whereas before the upgrade the default video output would always be
> > the monitor attached to the dock if my laptop was in the dock (which was
> > what I wanted), now X refuses to see the dock at all, and it will only come
> > up on the laptop screen.
> >
> > The console works just fine on the dock's monitor, and I double-checked the
> > bios to make sure that the dock is set as primary video out. I also
> > commented out all mentions of the laptop's screen from xorg.conf, but it
> > steadfastly insists on coming up only on the laptop.
> >
> > All my ports are up to date, including kde 3.5.8, and nvidia-driver
> > 100.14.19. I also tried with and without the -ignoreABI option, no change.
> > I should also point out that I'm using kdm, but I was using it before the
> > upgrade too. Turning kdm off and using startx has no effect (still comes up
> > only on the laptop screen).
>
> > Any suggestions?
>
> The content of /var/log/Xorg.0.log might be useful,

http://people.freebsd.org/~dougb/Xorg.0.log

There are a couple of interesting sections:
(II) PCI: Probing config type using method 1
(II) PCI: Config type is 1
(II) PCI: stages = 0x03, oldVal1 = 0x00000000, mode1Res1 = 0x80000000
(WW) OS did not count PCI devices, guessing wildly

and
(--) NVIDIA(0): Connected display device(s) on Quadro NVS 110M at 
PCI:1:0:0:
(--) NVIDIA(0):     DELL 2001FP (CRT-0)
(--) NVIDIA(0):     LPL (DFP-0)
(--) NVIDIA(0): DELL 2001FP (CRT-0): 400.0 MHz maximum pixel clock
(--) NVIDIA(0): LPL (DFP-0): 330.0 MHz maximum pixel clock
(--) NVIDIA(0): LPL (DFP-0): Internal Dual Link LVDS

That all looks right, but

(II) NVIDIA(0): Assigned Display Device: DFP-0

That should not be, since the only screen mentioned in xorg.conf 
(http://people.freebsd.org/~dougb/xorg.conf) is the 2001FP.

(WW) NVIDIA(0): No valid modes for "1600x1200"; removing.

This makes sense because the laptop screen doesn't do that resolution, 
it's for the 2001FP.

> but also try and play with xrandr.  Xrandr --verbose should tell you 
> what outputs i actually sees, and then you can disable/enable individual 
> outputs and see what happens.

Screen 0: minimum 320 x 240, current 1440 x 900, maximum 1440 x 900
default connected 1440x900+0+0 (0x19a) normal (normal) 0mm x 0mm
        Identifier: 0x199
        Timestamp:  811385259
        Subpixel:   unknown
        Clones:
        CRTC:       0
        CRTCs:      0
  1440x900 (0x19a)   64.8MHz
        h: width  1440 start    0 end    0 total 1440 skew    0 clock 
45.0KHz
        v: height  900 start    0 end    0 total  900           clock 
50.0Hz
...

No mention of the 2001FP at all.


Thanks again,

Doug

--

    This .signature sanitized for your protection

_______________________________________________
freebsd-ports_(_at_)_freebsd_(_dot_)_org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-ports
To unsubscribe, send any mail to "freebsd-ports-unsubscribe_(_at_)_freebsd_(_dot_)_org"