[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

kern/72509: [em0]/[vga] Computer graphics interface or network interface freezes due to heavy load



>Number:         72509
>Category:       kern
>Synopsis:       [em0]/[vga] Computer graphics interface or network interface freezes due to heavy load
>Confidential:   no
>Severity:       serious
>Priority:       high
>Responsible:    freebsd-bugs
>State:          open
>Quarter:        
>Keywords:       
>Date-Required:
>Class:          sw-bug
>Submitter-Id:   current-users
>Arrival-Date:   Mon Oct 11 12:40:25 GMT 2004
>Closed-Date:
>Last-Modified:
>Originator:     O. Hartmann
>Release:        FreeBSD 5.3-BETA7 i386
>Organization:
Department of Geophysics, Johannes Gutenberg-Universitaet
>Environment:
System: FreeBSD edda.physik.uni-mainz.de 5.3-BETA7 FreeBSD 5.3-BETA7 #0: Mon Oct 11 07:09:31 UTC 2004 root_(_at_)_edda_(_dot_)_physik_(_dot_)_uni-mainz_(_dot_)_de:/usr/obj/usr/src/sys/EDDA i386


	ASUS CUR-DLS, SMP, two 866MHz PIII, PCI onboard vga (ATI Rage XL), PREEMPTION, Xorg X11
	64Bit em0 (Intel) GBit NIC
>Description:
	FreeBSD 5.3-BETA7 (also BETA5 and BETA6) freezes after heavy load on X11 or NIC freezes
	after a while and leaves computer system without network connection while the system is
	still up and running. The NIC wedging is rare, but I can force the machine's freezing 
	by doing a lot of graphical activitis like showing a 170 MB big geophysical TIFF map 
	in ImageMagick's 'display' or using intensively Mozilla in the most recent stable 
	version.

	Environemnt: FreeBSD 5.3-BETA7, buildworld done today the last time. Xorg as taken from the
	ports, I think the most recent port's version. ImageMagick and Mozilla as compiled 
	a few days ago. Kernel config as taken from GENERIC, but with PREEMPTION enabled and several
	unused drivers disabled. The problems occur also with a conservative GENERIC and UP kernel!
	While 'ongoing to freeze' sometimes I have the chance to change to the console (Ctrl-Alt-F1)
	the machine changes to console and begins to beep (sustaining beep).
	
	I did some hardware stress tests with memtest/memtest86, burnP6 and BurnMMX/burnBX to
	ensure memory and CPUs are all right. Stressing hardware over several hours did not
	take any effect. 

	Using the same system in a non-conservative SMP environment without graphics leaves 
	the machine very long in an operative state, but suddenly network connection gets lost,
	not ping in, no ping out while the state of the em0 adapter is still shown as UP.

	dmesg output:

Copyright (c) 1992-2004 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD 5.3-BETA7 #0: Mon Oct 11 07:09:31 UTC 2004
    root_(_at_)_edda_(_dot_)_physik_(_dot_)_uni-mainz_(_dot_)_de:/usr/obj/usr/src/sys/EDDA
ACPI APIC Table: <ASUS   CUR-DLS >
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel Pentium III (866.70-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0x68a  Stepping = 10
  Features=0x387fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,PN,MMX,FXSR,SSE>
real memory  = 1073721344 (1023 MB)
avail memory = 1041166336 (992 MB)
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
 cpu0 (BSP): APIC ID:  3
 cpu1 (AP): APIC ID:  0
ioapic0 <Version 1.1> irqs 0-15 on motherboard
ioapic1 <Version 1.1> irqs 16-31 on motherboard
netsmb_dev: loaded
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
acpi0: <ASUS CUR-DLS> on motherboard
acpi0: Power Button (fixed)
Timecounter "ACPI-safe" frequency 3579545 Hz quality 1000
acpi_timer0: <32-bit timer at 3.579545MHz> port 0xe408-0xe40b on acpi0
cpu0: <ACPI CPU> on acpi0
cpu1: <ACPI CPU> on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
fxp0: <Intel 82559 Pro/100 Ethernet> port 0xd800-0xd83f mem 0xfd800000-0xfd8fffff,0xfe000000-0xfe000fff irq 20 at device 2.0 on pci0
miibus0: <MII bus> on fxp0
inphy0: <i82555 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp0: Ethernet address: 00:e0:18:05:73:f4
ahc0: <Adaptec 2940 Ultra SCSI adapter> port 0xd400-0xd4ff mem 0xfd000000-0xfd000fff irq 17 at device 4.0 on pci0
ahc0: [GIANT-LOCKED]
aic7880: Ultra Wide Channel A, SCSI Id=7, 16/253 SCBs
pcm0: <AudioPCI ES1373-8> port 0xd000-0xd03f irq 19 at device 6.0 on pci0
pcm0: <Cirrus Logic CS4297A AC97 Codec>
pcm0: [GIANT-LOCKED]
pci0: <display, VGA> at device 7.0 (no driver attached)
isab0: <PCI-ISA bridge> port 0xe800-0xe80f at device 15.0 on pci0
isa0: <ISA bus> on isab0
pci0: <mass storage, ATA> at device 15.1 (no driver attached)
pcib1: <ACPI Host-PCI bridge> on acpi0
pci1: <ACPI PCI bus> on pcib1
em0: <Intel(R) PRO/1000 Network Connection, Version - 1.7.25> port 0xb000-0xb03f mem 0xfa800000-0xfa81ffff irq 22 at device 3.0 on pci1
em0: Ethernet address: 00:07:e9:14:8f:7b
em0:  Speed:N/A  Duplex:N/A
sym0: <1010-33> port 0xa800-0xa8ff mem 0xf9800000-0xf9801fff,0xfa000000-0xfa0003ff irq 24 at device 5.0 on pci1
sym0: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking
sym0: open drain IRQ line driver, using on-chip SRAM
sym0: using LOAD/STORE-based firmware.
sym0: handling phase mismatch from SCRIPTS.
sym0: [GIANT-LOCKED]
sym1: <1010-33> port 0xa400-0xa4ff mem 0xf8800000-0xf8801fff,0xf9000000-0xf90003ff irq 25 at device 5.1 on pci1
sym1: Symbios NVRAM, ID 7, Fast-80, LVD, parity checking
sym1: open drain IRQ line driver, using on-chip SRAM
sym1: using LOAD/STORE-based firmware.
sym1: handling phase mismatch from SCRIPTS.
sym1: [GIANT-LOCKED]
atkbdc0: <Keyboard controller (i8042)> port 0x64,0x60 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: model IntelliMouse, device ID 3
sio0 port 0x3f8-0x3ff irq 4 on acpi0
sio0: type 16550A
sio1 port 0x2f8-0x2ff irq 3 on acpi0
sio1: type 16550A
fdc0: <floppy drive controller> port 0x3f7,0x3f0-0x3f5 irq 6 drq 2 on acpi0
fdc0: [FAST]
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
orm0: <ISA Option ROMs> at iomem 0xd0000-0xd3fff,0xc0000-0xca7ff on isa0
pmtimer0 on isa0
ppc0: parallel port not found.
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <8 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
fb0 at vga0
Timecounters tick every 1.000 msec
IP Filter: v3.4.35 initialized.  Default = block all, Logging = enabled
Waiting 5 seconds for SCSI devices to settle
(noperiph:sym0:0:-1:-1): SCSI BUS reset delivered.
(noperiph:sym1:0:-1:-1): SCSI BUS reset delivered.
cd0 at ahc0 bus 0 target 0 lun 0
cd0: <TEAC CD-ROM CD-532S 1.0A> Removable CD-ROM SCSI-2 device 
cd0: 20.000MB/s transfers (20.000MHz, offset 15)
cd0: cd present [328150 x 2048 byte records]
da0 at sym0 bus 0 target 0 lun 0
da0: <IBM IC35L018UWD210-0 S5BS> Fixed Direct Access SCSI-3 device 
da0: 160.000MB/s transfers (80.000MHz, offset 62, 16bit), Tagged Queueing Enabled
da0: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C)
da1 at sym0 bus 0 target 1 lun 0
da1: <IBM DDYS-T18350N S96H> Fixed Direct Access SCSI-3 device 
da1: 160.000MB/s transfers (80.000MHz, offset 62, 16bit), Tagged Queueing Enabled
da1: 17501MB (35843670 512 byte sectors: 255H 63S/T 2231C)
da2 at sym0 bus 0 target 2 lun 0
da2: <FUJITSU MAJ3182MP 5207> Fixed Direct Access SCSI-3 device 
da2: 160.000MB/s transfers (80.000MHz, offset 62, 16bit), Tagged Queueing Enabled
da2: 17429MB (35694904 512 byte sectors: 255H 63S/T 2221C)
SMP: AP CPU #1 Launched!
cd1 at ahc0 bus 0 target 1 lun 0
cd1: <PLEXTOR CD-R   PX-R412C 1.07> Removable CD-ROM SCSI-2 device 
cd1: 10.000MB/s transfers (10.000MHz, offset 8)
cd1: Attempt to query device size failed: NOT READY, Medium not present
Mounting root from ufs:/dev/da0s1a
WARNING: / was not properly dismounted
WARNING: /compat was not properly dismounted
WARNING: /homes was not properly dismounted
WARNING: /usr was not properly dismounted
WARNING: /usr/data was not properly dismounted
WARNING: /usr/local was not properly dismounted
WARNING: /usr/obj was not properly dismounted
WARNING: /usr/ports was not properly dismounted
WARNING: /usr/scratch was not properly dismounted
WARNING: /usr/src was not properly dismounted
WARNING: /var was not properly dismounted
em0: Link is up 100 Mbps Full Duplex

>How-To-Repeat:
	Do a lot of graphics, stress your VGA adaptor, stress NIC.


>Fix:

	


>Release-Note:
>Audit-Trail:
>Unformatted:

Visit your host, monkey.org